NETGEAR ProSafe FSM7326P Cli Reference Manual page 32

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
The command prompt changes in each command mode to help you identify the current
mode. Table 2-5 describes the command modes and the prompts visible in that mode.
Table 2-5. CLI Command Modes
Command Mode
User EXEC
Privileged EXEC
Global Config
VLAN Config
Interface Config
Line Config
Policy Map Config
Policy Class Config
Class Map Config
Router OSPF
Config
2-6
Prompt
Switch>
Switch#
Switch (Config)#
Switch (Vlan)#
Switch (Interface <unit/slot/
port>)#
Switch (line)#
Switch (Config policy-map)#
Switch (Config policy-class-map)#
Switch (Config class-map)#
Switch (Config router)#
v1.0, March 2006
Mode Description
Contains a limited set of
commands to view basic system
information.
Allows you to issue any EXEC
command, enter the VLAN
Global
mode, or enter the
Config
uration mode.
Groups general setup commands
and permits you to make
modifications to the running
configuration.
Groups all the VLAN commands.
Allows you to enable or modify
the operation of an interface and
provides access to the router
interface configuration
commands.
Use this mode to set up a
physical port for a specific logical
connection operation.
Allows you to configure various
telnet settings and the console
interface.
Allows you to access the QoS
Policy-Map configuration mode
to configure the QoS Policy-Map.
Consists of class creation,
deletion, and matching
commands. The class match
commands specify Layer 2,
Layer 3, and general match
criteria.
Allows you to access the QoS
Class-Map configuration mode to
configure QoS class maps.
Allows you to access the router
OSPF configuration commands.
Overview