Distance Ospf; Distribute-List Out - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

14.6.23 distance ospf

This command sets the route preference value of OSPF in the router. Lower route
preference values are preferred when determining the best route. The type of OSPF can be
intra, inter, type-1, or type-2. The OSPF specification (RFC 2328) requires that
preferences must be given to the routes learned via OSPF in the following order: intra <
inter < type-1 < type-2. The <
Default
Format
Mode
14.6.23.1 no distance ospf
This command sets the default route preference value of OSPF in the router.
Format
Mode

14.6.24 distribute-list out

Use this command to specify the access list to filter routes received from the source
protocol.
Format
Mode
14.6.24.1 no distribute-list out
Use this command to specify the access list to filter routes received from the source
protocol.
Format
Mode
14-40
> range is 1 to 255.
preference
intra - 8; inter - 10; type-1, 13; type-2, 50.
distance ospf {intra | inter | type1 | type2}
<preference>
Router OSPF Config
no distance ospf {intra | inter | type1 | type2}
Router OSPF Config
distribute-list <1-199> out {rip | bgp | static |
connected}
Router OSPF Config
no distribute-list <1-199> out {rip | bgp | static
| connected}
Router OSPF Config
v1.0, March 2006
Routing Commands