Show Diffserv Service Brief; Show Policy-Map Interface - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Policy Name
Policy Details

13.6.5 show diffserv service brief

This command displays all interfaces in the system to which a DiffServ policy has been
attached. The inbound direction parameter is optional.
Format
Mode
DiffServ Mode
The following information is repeated for interface and direction (only those interfaces
configured with an attached policy are shown):
Interface
Direction
OperStatus
Policy Name

13.6.6 show policy-map interface

This command displays policy-oriented statistics information for the specified interface
and direction. The
system.
Note: This command is only allowed while the DiffServ administrative mode is
Format
Mode
Interface
Quality of Service (QoS) Commands
The name of the policy attached to the interface in the indi-
cated direction.
Attached policy details, whose content is identical to that
described for the show policy-map
mand (content not repeated here for brevity).
show diffserv service brief [in]
Privileged EXEC
The current setting of the DiffServ administrative mode. An
attached policy is only active on an interface while DiffServ
is in an enabled mode.
Valid slot and port number separated by forward slashes.
The traffic direction of this interface service.
The current operational status of this DiffServ service inter-
face.
The name of the policy attached to the interface in the indi-
cated direction.
<unit/slot/port>
enabled.
show policy-map interface <unit/slot/port> [in]
Privileged EXEC
Valid slot and port number separated by forward slashes.
v1.0, March 2006
parameter specifies a valid interface for the
com-
<policymapname>
13-27