Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
13.3.10 match protocol
This command adds to the specified class definition a match condition based on the value
of the IP Protocol field in a packet using a single keyword notation or a numeric value
notation.
To specify the match condition using a single keyword notation, the value for <
is one of the supported protocol name keywords. The currently supported values are:
name>
icmp, igmp, ip, tcp, udp
To specify the match condition using a numeric value notation, the protocol number is a
standard value assigned by IANA and is interpreted as an integer from 0 to 255.
Note: This command does not validate the protocol number value against the
Format
Mode
13.3.11 match srcip
This command adds to the specified class definition a match condition based on the source
IP address of a packet. The
parameter specifies an IP address bit mask and must consist of a contiguous set of leading
1 bits.
Format
Mode
13.3.12 match srcl4port
This command adds to the specified class definition a match condition based on the source
layer 4 port of a packet using a single keyword or numeric notation.
To specify the match condition as a single keyword notation, the value for
one of the supported port name keywords (listed below).
The currently supported
. Each of these translates into its equivalent port number, which is used as both the
tftp, www
start and end of a port range.
Quality of Service (QoS) Commands
. A value of ip is matches all protocol number values.
current list defined by IANA.
match protocol {protocol-name | <0-255>}
Class-Map Config
<ipaddr>
match srcip <ipaddr> <ipmask>
Class-Map Config
values are:
<portkey>
v1.0, March 2006
parameter specifies an IP address. The
domain, echo, ftp, ftpdata, http, smtp, snmp, telnet,
protocol-
<ipmask>
is
<portkey>
13-15