Exit-Overflow-Interval; External-Lsdb-Limit - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

14.6.25 exit-overflow-interval

This command configures the exit overflow interval for OSPF. It describes the number of
seconds after entering Overflow state that a router will wait before attempting to leave the
Overflow State. This allows the router to again originate non-default AS-external-LSAs.
When set to 0, the router will not leave Overflow State until restarted. The range for
is 0 to 2147483647 seconds.
<seconds>
Default
Format
Mode
14.6.25.1 no exit-overflow-interval
This command configures the default exit overflow interval for OSPF.
Format
Mode

14.6.26 external-lsdb-limit

This command configures the external LSDB limit for OSPF. If the value is -1, then there
is no limit. When the number of non-default AS-external-LSAs in a router's link-state
database reaches the external LSDB limit, the router enters overflow state. The router
never holds more than the external LSDB limit non-default AS-external-LSAs in it
database. The external LSDB limit MUST be set identically in all routers attached to the
OSPF backbone and/or any regular OSPF area. The range for <
2147483647.
Default
Format
Mode
14.6.26.1 no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
Format
Mode
Routing Commands
0
exit-overflow-interval <0-2147483647>
Router OSPF Config
no exit-overflow-interval
Router OSPF Config
-1
external-lsdb-limit <-1-2147483647>
Router OSPF Config
no external-lsdb-limit
Router OSPF Config
v1.0, March 2006
> is -1 to
limit
14-41