Show Spanning-Tree Mst Port Detailed - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Port Up Time
Since Counters
Last Cleared
STP BPDUs
Transmitted
STP BPDUs
Received
RST BPDUs
Transmitted
RST BPDUs
Received
MSTP BPDUs
Transmitted
MSTP BPDUs
Received

5.2.4 show spanning-tree mst port detailed

This command displays the detailed settings and parameters for a specific switch port
within a particular multiple spanning tree instance. The parameter
that corresponds to the desired existing multiple spanning tree instance. The
is the desired switch port.
port>
Format
Mode
MST Instance ID
Port Identifier
Port Priority
Spanning Tree Protocol Commands
Time since port was reset, displayed in days, hours, minutes,
and seconds.
Spanning Tree Protocol Bridge Protocol Data Units sent
Spanning Tree Protocol Bridge Protocol Data Units received.
Rapid Spanning Tree Protocol Bridge Protocol Data Units
sent
Rapid Spanning Tree Protocol Bridge Protocol Data Units
received.
Multiple Spanning Tree Protocol Bridge Protocol Data Units
sent
Multiple Spanning Tree Protocol Bridge Protocol Data Units
received.
show spanning-tree mst port detailed <mstid>
<unit/slot/port>
Privileged EXEC
User EXEC
The ID of the existing MST instance.
The port identifier for the specified port within the selected
MST instance. It is made up from the port priority and the
interface number of the port.
The priority for a particular port within the selected MST
instance. The port priority is displayed in multiples of 16.
v1.0, March 2006
is a number
<mstid>
<unit/slot/
5-13