Host; Lease; Network - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

7.1.7 host

This command specifies the IP address and network mask for a manual binding to a DHCP
client. Address and Mask are valid IP addresses; each made up of four decimal bytes
ranging from 0 to 255. IP address 0.0.0.0 is invalid. The prefix-length is an integer from 0
to 32
Default
Format
Mode
7.1.7.1 no host
This command removes the IP address of the DHCP client.
Format
Mode

7.1.8 lease

This command configures the duration of the lease for an IP address that is assigned from
a DHCP server to a DHCP client. The overall lease time should be between 1-86400
minutes. If infinite is specified, lease is set for 60 days. Days is an integer from 0 to 59.
Hours is an integer from 0 to 1439. Minutes is an integer from 0 to 86399.
Default
Format
Mode
7.1.8.1 no lease
This command restores the default value of the lease time for DHCP Server.
Format
Mode

7.1.9 network

Use this command to configure the subnet number and mask for a DHCP address pool on
the server. Network-number is a valid IP address, made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified
address pool. The prefix-length is an integer from 0 to 32.
DHCP Commands
none
host <address> [mask | prefix-length]
DHCP Pool Config
no host
DHCP Pool Config
1 (day)
lease {[<days> [hours] [minutes]] | [infinite]}
DHCP Pool Config
no lease
DHCP Pool Config
v1.0, March 2006
7-5