Show Switch - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

17.1.14 show switch

This command displays information about all units in the stack or a single unit when you
specify the unit value.
Format
Mode
Switch
When you do not specify a value for unit, the following information appears:
Management
Status
Preconfigured
Model Identifier
Plugged-In Model
Identifier
Switch Status
Code Version
When you specify a value for unit, the following information appears:
Management
Status
Hardware
Management
Preference
17-8
show switch [unit]
Privileged EXEC
The unit identifier assigned to the switch.
This field indicates whether the switch is the Primary Man-
agement Unit, a stack member, or the status is unassigned.
The model identifier of a preconfigured switch ready to join
the stack. The Model Identifier is a 32-character field
assigned by the device manufacturer to identify the device.
This field displays the model identifier of the switch in the
stack. Model Identifier is a 32-character field assigned by the
device manufacturer to identify the device.
This field indicates the switch status. Possible values for this
state are: OK, Unsup ported, Code Mismatch, Config Mis-
match, or Not Present.
This field indicates the detected version of code on this
switch.
This field indicates whether the switch is the Primary Man-
agement Unit, a stack member, or the status is unassigned.
The hardware management preference of the switch. The
hardware management preference can be disabled or unas-
signed.
v1.0, March 2006
Stacking Commands