Table of Contents
Advertisement
Hub Interface
7.1
Signal Naming Convention
Figure 74
component. This figure is intended to give a quick naming cross reference to designers. The
specific guidelines and implementation on these signals are given in the following sections.
Note: Throughout the document, the 'x' part of the MCH signal has been dropped for simplicity.
Figure 74.
Signal Naming Convention on Both Sides of the Hub Interfaces
NOTES:
1. These signals have individual resistor dividers. For specific values, refer to
2. These signals have individual pull-up resistors. For specific values, refer to
3. Signal names for HI2.0 on the MCH: x = Hub Interface B, C, or D.
Design Guide
®
Intel
Pentium
has the Hub Interface 2.0 and Hub Interface 1.5 signal naming convention for each
®
M Processor and Intel
®
E7501 Chipset Platform
Hub Interface
Chipset
Figure 78
and
Figure
81.
Figure 79
and
Figure
82.
7
113
Advertisement
Table of Contents
