4.3.5
Graphical User Interface
The following window appears on the screen when the MCS is started:
The window name (Monitoring Control Software) is followed by the name of the MCS
Document opened by the Monitoring & Control Software.
4.3.5.1
MCS Login Window
The MCS login window enables to connect or disconnect to the Cortex SPS and check the connection
status. The connection buttons are disabled if no machine name or IP address is provided in the host
identification zone. Start entering the machine name or IP address and the connection button will
automatically be enabled.
Connect the MCS to the SPS by clicking on
machine accepts the connection, the disconnection button
turns to
. Otherwise, a connection error message appears on the screen.
© Safran Data Systems – IMP000074 e14r1
HIGH DATA RATE RECEIVER
HDR-4G+ USER'S MANUAL
Figure 81: MCS Top-Level Window
Figure 82: MCS Login Window
or by pressing the RETURN or ENTER key. If the host
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref.
DTU 100782
Is.Rev
3.5
Date:
June 1, 2021
is enabled and the connection status
Safran Data Systems
.
Page 215