Other Status And Alarms; Ber" Window; Decoding" Window; Vector" Window - Safran CORTEX Series User Manual

4.5.6.1.3

Other status and alarms

The upper right part of the window gives general information concerning the DCU. When everything is
configured right, it displays.
When an incorrect configuration is detected (different bitrates of both demodulators, same IF input...),
the box displays "Warning" (red). A tool tip is displayed when the pointer stops on the box. Below
stands an example of an incorrect configuration:

"BER" Window

4.5.6.2
This window enables the user to monitor the BER at the output of the combining system. Please refer
to the Demodulator Unit section for further details on this feature.

"Decoding" Window

4.5.6.3
This window enables the user to control and monitor the decoding features (Viterbi, TCM) at the output
of the combining system. Please refer to the Demodulator Unit section for further details on this feature.

"Vector" Window

4.5.6.4
This window enables the user to monitor the constellation at the output of the combining unit. It is the
same as the standard demodulator Vector windows, with the exception of three status (IF level,
Amplitude Error, Phase Error) that do not apply to the combining feature. Please refer to the
Demodulator Unit section for further details on this window.
© Safran Data Systems – IMP000074 e14r1
HIGH DATA RATE RECEIVER
HDR-4G+ USER'S MANUAL
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
Safran Data Systems
.
Page 306