Safran CORTEX Series User Manual page 274

If Separate I/Q BER display requested or in UQPSK demodulation:
BER I
NUMBER OF ERROR I
BER Q
NUMBER OF ERROR Q
For BER measurement in File mode, for each associated DPU:
BER DPU N
NUMBER OF ERROR DPU N
Note: From this window, by clicking on "Show DPU Details", it is possible to view the BER values
computed at the output of each DPU associated with the DMU and the used BER mode.
© Safran Data Systems – IMP000074 e14r1
HIGH DATA RATE RECEIVER
HDR-4G+ USER'S MANUAL
Display a BER value between 0 and 1, or
No data if the demodulation chain is unlocked or if the total number of bits
regenerated by the bit synchronizer is less than the programmed value for
parameter BER Counter.
Number of bits in error since the BER counter was reset.
Display a BER value between 0 and 1, or
No data if the demodulation chain is unlocked or if the total number of bits
regenerated by the bit synchronizer is less than the programmed value for
parameter BER Counter.
Number of bits in error since the BER counter was reset.
Display a BER value between 0 and 1, for DPU #N
Number of bits in error since the BER counter was reset for DPU #N
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
Safran Data Systems
.
Page 274