Satellites Configuration Examples - Safran CORTEX Series User Manual

6 S C
ATELLITES ONFIGURATION
Next table is a non-exhaustive list of in-orbit satellites with their main downlink configuration
parameters: modulation, bit rate, PCM code, Viterbi mode, output mode.
These parameters can be entered manually on the CORTEX HDR or, more easily, by loading the MCS
file indicated in the left column. These MCS files can be found in:
Reminder: procedure for configuring the CORTEX HDR from an MCS file:
1. Click on FILE, CLOSE. If necessary, save the current configuration to the active MCS
document.
2. Click on FILE, OPEN. Select a new MCS document in the list and click on OK to load it. The
configuration status turns to
the previous one).
3. Enable the configuration mode if necessary (click on
Configuration password).
4. Reconfigure the unit by clicking on
SATELLITE INFORMATION LISTED IN THIS SECTION IS NOT CONTRACTUAL
THE OPERATOR SHOULD KNOW THE DETAILED FEATURES OF THE TRACKED SATELLITE
© Safran Data Systems – IMP000074 e14r1
HIGH DATA RATE RECEIVER
HDR-4G+ USER'S MANUAL
E
XAMPLES
C:\Program Files\IN-SNEC\CrtxMcs\Default\Config
(unless the new MCS document is strictly identical to
. The configuration status turns to
WARNING:
AND PROGRAM THE CORTEX
It cannot be duplicated or distributed without expressed written consent.
Ref. DTU 100782
Is.Rev
Date:
in the lower toolbar and enter the
HDR
ACCORDINGLY
Safran Data Systems
This document is the property of
3.5
June 1, 2021
.
.
.
.
Page 369