Data Output - Safran CORTEX Series User Manual

3.4.13.4

Data output

Data at the output of each DPU can be recorded in specific directories of the internal hard disk named
"T" or/and output at the ECL connectors as a single data stream with its clock.
The recording directories architecture is the following:
The report files are recorded in:
T:\DiskController_1_00\Report_TMA for DPU A
T:\DiskController_1_00\Report_TMB for DPU B
T:\DiskController_1_00\Report_TMC for DPU C
T:\DiskController_1_00\Report_TMD for DPU D
T:\DiskController_1_00\Report_TME for DPU E
T:\DiskController_1_00\Report_TMF for DPU F
T:\DiskController_1_00\Report_TMG for DPU G
T:\DiskController_1_00\Report_TMH for DPU H
The data files are recorded in:
T:\DiskController_1_01\.... for DPU A
T:\DiskController_1_03\.... for DPU C
T:\DiskController_1_05\.... for DPU E
T:\DiskController_1_07\.... for DPU G
T:\DiskController_1_02\.... for DPU B
T:\DiskController_1_04\.... for DPU D
T:\DiskController_1_06\.... for DPU F
T:\DiskController_1_08\.... for DPU H
If the CCSDS Virtual Channel sorting is disabled (TFP window), the data files are recorded inside the
sub-directories CV_XX of each directory.
If the CCSDS Virtual Channel sorting is enabled, the data files are recorded inside the specific sub-
directories: CV_NN with NN = 00 to 63 being the Virtual Channel ID number.
Multi-DPU outputs on ECL connectors are described in chapter 2.
© Safran Data Systems – IMP000074 e14r1
HIGH DATA RATE RECEIVER
HDR-4G+ USER'S MANUAL
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
Safran Data Systems
.
Page 146