Mcs Graphical User Interface; Figure 78: Mcs Menu Management Window - Safran CORTEX Series User Manual

The following commands are supported:
 Stop the active menu: the CORTEX application software is not stopped but all IP connections
(to the monitoring port, telemetry port, ranging ports, etc...), except the connections to the RAC
port, are automatically closed. The connection status on the top level window of the GUI
indicates DISCONNECTED.
 Start a new menu: select and start a new menu.
 Check the active menu: indicates the active menu.
 Load the menu table: on reception of this command, the CORTEX returns the list of available
menus.
4.2.4.2

MCS Graphical User Interface

From the IN-SNEC MCS, the operator can access the RAC server by clicking successively, in the
upper toolbar, on Window  Menu_Selection, or by clicking on the
Next picture shows the operational scenarios offered by the start-up menu. Use the Stop active menu
and Start new menu pushbuttons to re-configure the CORTEX.
© Safran Data Systems – IMP000074 e14r1
HIGH DATA RATE RECEIVER
HDR-4G+ USER'S MANUAL

Figure 78: MCS Menu Management Window

This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
icon.
Safran Data Systems
.
Page 190