Software Exit & Cortex Hdr Shutdown; Exiting The Monitoring & Control Software; Exiting The Signal Processing Software; Restarting The Sps & Mcs - Safran CORTEX Series User Manual

4.1.3 Software Exit & CORTEX HDR Shutdown
4.1.3.1 Exiting the Monitoring & Control Software
To exit the Monitoring & Control Software, click on File menu and select Exit. or click on
upper right corner of the MCS window. If any configuration parameter has been changed since the
MCS Document was updated on the disk, the following message is displayed:
Click on Yes to update the MCS File on the disk. Otherwise, click on No or Cancel the command.
4.1.3.2

Exiting the Signal Processing Software

To exit the Signal Processing Software (SPS), click on the SPS icon
the screen and select Exit.
4.1.3.3 Restarting the SPS & MCS
Assuming the application software (SPS + MCS) has been stopped, click on shortcut menu Start / All
Programs / Startup / crtxstart to restart it.
To restart the MCS only, click on shortcut menu Start / All Programs / Cortex Application / MCS.
To restart the SPS only, click on shortcut menu Start / All Programs / Cortex Application / SPS.
4.1.3.4

CORTEX HDR Shutdown

S PC-
HUT DOWN THE COMPATIBLE WORKSTATION
FAILU E TO
R OBSERVE THIS PROCEDURE CAN AFFECT DATA ON THE DISK AND THE SYSTEM ITSELF
4.1.4

Screen Saver

THE SCREEN SAVER INSTALLED AT DELIVERY ENABLES TO SWITCH THE LCD BACKLIGHT OFF
TO AVOID PREMATURE AGEING
DO NOT CHANGE THE SCREEN SAVER SETTING.
© Safran Data Systems – IMP000074 e14r1
HIGH DATA RATE RECEIVER
HDR-4G+ USER'S MANUAL
P
RIOR TO SWITCHING OFF YOUR
(
CLICK ON
W
ARNING
/ LCD
FAILURE OF THE
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
CORTEX PRODUCT
Start / Shutdown / Shut down the computer).
:
AND DATA TRANSFER PROBLEMS ON THE
Safran Data Systems
in the
at the lower right part of
.
.
PCI ,
BUS
.
Page 186