Control; Monitoring - Safran CORTEX Series User Manual

4.5.5.3.1

Control

Unless otherwise specified, parameters in this window are described in DPU.
OPERATING MODE
INVERSE
TESTED DATA
FILE NUMBER
BER PATTERN
NUMBER
BER COUNTER
4.5.5.3.2

Monitoring

Unless otherwise specified, status & alarms in this window are described in DPU.
BER
NUMBER OF ERROR
© Safran Data Systems – IMP000074 e14r1
HIGH DATA RATE RECEIVER
HDR-4G+ USER'S MANUAL
BER measurement mode (simulated data for BER analyzis):
Off BER measurement stopped
File Simulated data from a file on the
PseudoDxx Pseudo random data, using from PN generator xx
(where xx = 7, 10, 11, 15, 23 or 31)
Inverse (Enable) or not (Disable) the data used for BER computation
User Data Compute the BER only on the User data of the frames
(excluded added check symbols)
Whole Data Compute the BER on all the received data of the frames
Custom Pattern Compute the BER on a user-defined portion of the frame.
The custom BER pattern is defined inside an ASCII file stored on the hard
drive.
File number for BER in file mode: enter any value from 1 to N.
File number for user-defined BER pattern in Custom Pattern mode: enter any
value from 1 to N
Total number of bits to process for BER measurement in Pseudo mode
Resolution step: 65536 bits. In File Mode, Infinite accumulation.
Computed Bit Error Rate
Cumulated number of errors
It cannot be duplicated or distributed without expressed written consent.
Ref. DTU 100782
Is.Rev
Date:
Safran Data Systems
This document is the property of
3.5
June 1, 2021
.
Page 298