Xpol Configuration: File; Control; Figure 169: Xpol Configuration: File - Safran CORTEX Series User Manual

4.5.8.3.2.3

XPOL Configuration: File

4.5.8.3.2.4

Control

DOPPLER
E ( IF X)
NABLE ON
T
YPE
M (IF X)
ODE
R (IF X)
ANGE
R (IF X)
ATE
F (IF X)
ILE
XPOL
E
NABLE
T
YPE
© Safran Data Systems – IMP000074 e14r1
HIGH DATA RATE RECEIVER
HDR-4G+ USER'S MANUAL

Figure 169: XPOL Configuration: File

Enable or disable Doppler (Frequency Sweeping) on IF 1 and/or IF 2
Only when Doppler is available on both IF 1 & 2

Same: Same Doppler scheme on both IF

Independent: Independent Doppler schemes

Triangle

Sinusoidal

Atan

File
Doppler Range in Hz
Doppler Rate in Hz/s
When File Mode is enabled, this is the number of the selected File
The files can be found in D:\ZDS\DATA\HDR\SPS\DOPPLER\ and are named as
follows:
- File 1 will be named doppler1.csv
The files contain two columns: "time" and "offset"
"time" is the time offset in seconds
-
"offset" is the frequency offset
-
You can add "#REWIND#" at the end to loop on the file
Enable or disable Cross-Polarization

Still

File
It cannot be duplicated or distributed without expressed written consent.
Ref. DTU 100782
Is.Rev
Date:
Safran Data Systems
This document is the property of
3.5
June 1, 2021
.
Page 337