Risk Of Electric Shocks - Safran CORTEX Series User Manual

Powers sources
Only connect the apparatus to a power supply of the described in the operating instructions or as
marked on the apparatus.
Turning off the power switch does not completely isolate this product from the power line so remove the
plug from the socket if not using it for extended period of time.
Unplug this apparatus during lightning storms.
WARNING: The system must be connected to an electrical installation complying with the
standards applicable in your country. It must be equipped with overcurrent, overvoltage and earth
fault protections.
WARNING: The system must be plugged to electrical equipment in accordance with EN60950-1:
2006 2nd edition.
WARNING: This equipment has multiple power sources; all power sources shall be unplugged to
isolate the equipment.
Power supply cable and socket
This apparatus must be used with a power supply cable of 1 mm2 section minimum
WARNING: An isolator according to EN60947 standard serves as an isolating device. It must be
easily accessible and installed near the power supply.
The power supply plugs are used as safety device.
The power supply socket must be located at a distance of less than 1.5 m from the equipment
and easily accessible

RISK OF ELECTRIC SHOCKS

Opening of the product chassis
To reduce the risk of electric shock, do not remove cover (or back).
No user serviceable parts inside; the product chassis should only be opened by qualified
personnel for maintenance purpose (except for opposite instructions in the user's manual).
Power cord protection
Power supply cords should be routed so that they are not likely to be walked on or pinched by items
placed upon or against them, paying particular attention to cords and plugs, and the point where they
exit from the appliance
Water and moisture
To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The
presence of electricity near water can be dangerous. Do not use the apparatus near water.
© Safran Data Systems – IMP000074 e14r1
HIGH DATA RATE RECEIVER
HDR-4G+ USER'S MANUAL
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
Safran Data Systems
.
Page 26