Upper Toolbar; Common Data - Safran CORTEX Series User Manual

4.3.5.3

Upper Toolbar

4.3.5.3.1

Common Data

The following commands are common to all of the CORTEX products. For product specific commands,
see next section.
FILE NEW: Create a new MCS Document to open a new M&C session.
OPEN: Open an M&C session from an existing MCS Document on the disk
CLOSE: Close the current M&C session and document. If the document is not saved, a
messages proposes to save it. The workspace is closed too.
SAVE: Save the active MCS Document to the original document on the disk.
SAVE AS: Save and rename the active MCS Document to the disk.
PRINT: Print out the contents of the active MCS Table.
PRINT PREVIEW: Display the contents of the active MCS Table.
PAGE SETUP: Change the printer and printing options.
EXIT: Exit the MCS.
<file_list >: Select an existing MCS document from the list.
CONNECT TO: Connect the MCS to the monitoring port of a CORTEX. Command
CONNECT
available only if an IP address is provided in the host identification zone.
DISCONNECT: Close the monitoring connection to the CORTEX.
EXECUTE CONTROL ACCESS: Activate or inhibit the configuration mode.
OPEN CONTROL PORT: Open a TCP-IP connection to the Control port. Opening the
connection will inhibit access to the Control port by other remote Control Clients.
CLOSE CONTROL PORT: Close the TCP-IP connection to the Control port.
SPECIAL COMMANDS
© Safran Data Systems – IMP000074 e14r1
HIGH DATA RATE RECEIVER
HDR-4G+ USER'S MANUAL
I : Re-program the CORTEX to boot up state.
NITIALISATION
R D : Restart the acquisi11tion of the demodulator.
ESTART EMODULATOR
CLOSE TCP: Close the TCP-IP connection for the active window.
INITIALISATION: Re-program the CORTEX to boot up state.
LOAD CONFIGURATION: Load a User configuration
Ref.
Is.Rev
Date:
Safran Data Systems
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
DTU 100782
3.5
June 1, 2021
.
Page 217