Information On The Network Architecture - WAGO LONWORKS 750-319 Manual

4.2 Information on the network architecture

Attention
Please note the following information intended to place emphasis on meas-
ures to be used to allow a reliable and trouble-free communication especially
in networks of the Lonworks technology.
• Make sure that the specifications regarding transceiver, network topology,
• Select the installation location of the components such that the ambient
• Allow a 200 mm minimum spacing from high energy interference sources,
• Prior to connecting individual components, check whether the operating
• Mixing up the connections for data and current supply can lead to the de-
• On the basis of the documentation supplied, please obtain information as to
• Please note that the removal or addition of network components during the
• Should you fit coupling elements in the network, such as routers, repeaters,
Modular I/O System
®
L W
ON ORKS
network lengths and cable specifications etc. are adhered to.
temperature range tolerated by the components are observed and that any
heat produced can be dissipated.
e. g. frequency changers.
voltage corresponds to the parameters on the machine type plate. Please
pay particular attention to the fact whether direct current and/or alternate
current supply is possible or whether a particular polarity of the supply
voltage has to be observed.
struction of components!
which connections are coupled and/or what potential differences are per-
missible between connection points (e.g. signal mass, operating voltage).
running network operation implies risks relating to the data transmission
and destruction of components.
etc., make sure prior to connecting these coupling elements that conflicts
are excluded.
LON • 95