Ex4100 And Ex4100-F Network Cable And Transceiver Planning; Pluggable Transceivers And Cables Supported On Ex4100 And Ex4100-F Switches - Juniper EX4100 Hardware Manual

EX4100 and EX4100-F Network Cable and
Transceiver Planning
IN THIS SECTION

Pluggable Transceivers and Cables Supported on EX4100 and EX4100-F Switches | 101

SFP+ Direct Attach Copper Cables for EX Series Switches | 102
Overview of EX Series Switches: Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion | 105
Calculate the Fiber-Optic Cable Power Budget for EX Series Devices | 106
Calculating the Fiber-Optic Cable Power Margin for EX Series Devices | 107
Pluggable Transceivers and Cables Supported on EX4100 and EX4100-F
Switches
The Hardware Compatibility Tool
provides general information about those transceivers.
NOTE: We recommend that you use only optical transceivers and optical connectors purchased
from Juniper Networks with your Juniper Networks device.
CAUTION: The Juniper Networks Technical Assistance Center (JTAC) provides
complete support for Juniper-supplied optical modules and cables. However, JTAC does
not provide support for third-party optical modules and cables that are not qualified or
supplied by Juniper Networks. If you face a problem running a Juniper device that uses
third-party optical modules or cables, JTAC may help you diagnose host-related issues if
the observed issue is not, in the opinion of JTAC, related to the use of the third-party
optical modules or cables. Your JTAC engineer will likely request that you check the
third-party optical module or cable and, if required, replace it with an equivalent
Juniper-qualified component.
lists the transceivers that EX4100 and EX4100-F switches support and
101