Transmit Abort Timeout - Intermec JANUS 2020 User Manual

Timeout Delay (continued)
Timeout Delay, 2 sec
*$+IE3*
*$+IE3*
Timeout Delay, 20 sec
*$+IE5*
*$+IE5*
Timeout Delay, 60 sec
*$+IE7*
*$+IE7*

Transmit Abort Timeout

Purpose: Defines the length of time the reader waits to receive a message if one of these
conditions is true:
• CTS is continuously false for the timeout period.
• XOFF condition does not change within the timeout period.
• POL not received (polling protocol) within the timeout period.
Transmit Abort Timeout is similar to the Timeout Delay configuration, but it
only applies to the three conditions listed above.
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see "Communications Protocol,
Configure" earlier in this chapter.
Default: Disabled
Syntax: IHdata
Acceptable values for data are:
0
1-65000
To disable Transmit Abort Timeout, scan this bar code:
Scan:
Disable Transmit Abort Timeout
*$+IH0*
*$+IH0*
BC
NF
Disabled
Timeout in ms
Configuration Command Reference
Timeout Delay, 10 sec
*$+IE4*
*$+IE4*
Timeout Delay, 40 sec
*$+IE6*
*$+IE6*
12
12-93