Nortel DMS-100 Series Replacement Procedures page 39

and pressing the Enter key.
where
link no
is the number of the link connected to the faulty NT6X85 card
Repeat this command for each link to the faulty card.
At the frame
11
Put on a wrist strap.
12
Remove the NT6X85 card as shown in the following figures.
a Locate the card to be removed on the appropriate shelf.
DMS-100 Family NA100 Card Replacement Procedures Volume 6 of 7 LET0015 and up
XPM card replacement procedures (continued)
WARNING
Static electricity damage
Before removing any cards, put on a wrist strap and connect
it to the wrist strap grounding point on the left side of the
frame supervisory panel of the SMS. This protects the
equipment against damage caused by static electricity. Do
not replace more than one NT6X85 card at a time.
DANGER
Equipment damage
When removing or inserting a card, do not apply direct
pressure to the components and do not force the cards into
the slots.
NT6X85
in an SMS
(continued)
1-7