Driven Clutch Service (Ebs); Driven Clutch Slider Inspection; Driven Clutch Disassembly - Polaris RZR 900 2015 Service Manual

Table of Contents

DRIVEN CLUTCH SERVICE (EBS)

The square sliders can be inspected with the driven

clutch installed on the vehicle.

Using a feeler gauge, measure the distance between the

slider and the stationary sheave at the widest point

the measurement is over the service limit, the sliders or

driven clutch will need to be replaced. Also measure the

width of the slider block

smaller than the service limit.

Slider to Sheave Clearance

Service Limit: 0.175" (4.5 mm)

Slider Width

Service Limit: 0.975" (24.8 mm)

9926814 R08 -

. Replace the sliders if they are

1. Remove driven clutch from the transmission input

shaft. Do NOT attempt disassembly of the driven

clutch from the outside snap ring

clutch must be disassembled from the helix side.

If driven clutch is difficult to remove, use 2871056

Driven clutch puller to remove driven clutch.

2. It is important to mark the position of the shaft, cam

cover and sheave with a grease marker or tape

before disassembly or use the X's on the components

for reference. This will aid in assembly and maintains

clutch balance.

2015-2016 RZR 900

. The driven

2016 RZR S 1000 Service

Table of Contents