Tension Of The Drive Chain - Kodak X-Omat 2000 Service Manual

SERVICE MANUAL

Tension of the DRIVE CHAIN

TURNAROUND
ASSEMBLY
HOOK
10
SIDE PLATE
DRIVE
GEAR
ADJUSTING
4
SCREWS
4 HOLDING
SCREWS
LINK
DRIVE CHAIN
H172_1041CCA
H172_1041CA
[1] Check that the CHAIN is wet with solution.
[2] Check that the RACK is approximately the same
temperature as the solution.
Note
[3] Remove the RACK from the PROCESSOR.
[4] Place the RACK on a smooth, flat surface.
[5] Loosen the 4 HOLDING SCREWS.
[6] On the drive side, loosen the 2 ADJUSTING
SCREWS until the SCREWS do not touch the
SIDE PLATE of the TURNAROUND AY.
[7] Lift the RACK off of the surface and allow the
weight of the TURNAROUND AY to tighten the
CHAIN.
[8] Manually rotate the DRIVE GEAR one full
rotation.
[9] Tighten the 2 HOLDING SCREWS on the
DRIVE side.
[10] Tighten the 2 ADJUSTING SCREWS on the
DRIVE side until the SCREWS touch the SIDE
PLATE of the TURNAROUND AY.
[11] Observe the distance between the RACK SIDE
PLATE and TURNAROUND SIDE PLATE on
the DRIVE side.
[12] Rotate the 2 ADJUSTING SCREWS on the
NON-DRIVE side until the distance between the
SIDE PLATES is the same as the DRIVE side.
[13] Tighten the 2 HOLDING SCREWS on the NON-
DRIVE side.
12JAN99 – 7C8772