Table of Contents
Advertisement
C-11
Service Conditions (cont'd)
15.
The Camp-on by Station is not available for the target station in LINE LOCKOUT [L-3] condition.
16.
The Camp-on by Station is not available in the following cases:
a.) When the transferred station is dialing the number.
b.) When a call is terminating to the transferred station (the station is ringing).
c.) When the transferred station hears busy tone or reorder tone.
d.) When the transferred station hears special dial tone.
17.
The station allowed to set the Camp-on by Station (operating station) is only the D
station.
18.
When using Camp-on by Station, 1 Dial Hooking cannot be used.
19.
The station to be set the Camp-on by Station (transferred station) is the analog station, the D
ISDN terminal.
20.
When the Camp-on by Station is set to the D
a.) The ANSWER key of the D
b.) At the station to be set the Camp-on by Station, the LCD displays the service set indication
(CAMP) and the trunk kind or the calling number if the Caller ID notification is received.
21.
The following conditions should be considered when this service is set by manual operation (see Operating
Procedure) because the service becomes effective when the operating station is released from the
connection:
a.) When the operating station is not released within the predetermined time period after receiving
service set tone, the service which has been set will be ineffective. And the operating user hears
busy tone.
b.) When the transferred destination station becomes available before the transferring station is
released from the connection after the service was set (after the operating user hears service set
tone), the trunk incoming call is connected with the destination station after the operating station
(mediate party) replaces the handset.
c.) When the transferred destination station becomes LINE LOCKOUT condition or the destination
becomes make busy before the transferring station is released from the connection after the
service was set (after the operating user hears service set tone), the called station (mediate party)
is recalled even though the station is disconnected.
22.
The following are the conditions when the destination station does not answer within the time period of
No Answer timer:
a.) When the timer timeout occurs due to that the destination station has not answered within the
predetermined time period after the operating station is disconnected, the operating station is
called back.
b.) When the No Answer timer expires and the destination station has not answered within the
predetermined time period, the call management is decided by the system data (recall to the
operating station or CALL FORWARDING - DON'T ANSWER activation).
23.
The Service Conditions for Warning Tone are as follows:
a.) The destination station receives Call Waiting tone when Camp-on by Station has been set.
b.) The amount of time between tones is decided on a system basis.
24.
A call can be transferred to a station in the remote node via FCCS link.
25.
The Camp-on by Station can be set to the station in the self-office or the self-node in the FCCS network.
Interactions
1.
This feature is denied whenever the transferring station is engaged in any state other than a simple two-
party connection.
Page 162
Call Transfer - All Calls
term
:
term
lights when Warning Tone is received.
term
and the analog
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
term
and the
Advertisement
Table of Contents
