NEC NEAX2400 IPX Programming Manual page 657

Feature programming manual

Hide thumbs Also See for NEAX2400 IPX:

Table of Contents

Programming (cont'd)

MBTK - Assign the Make Idle status to the REMOTE ACCESS TO SYSTEM trunks.

ACSI - Assign Route Number, Trunk Number, and Connection Service Index (CSI) = 5, REMOTE

ACCESS TO SYSTEM, Incoming DDD Ring down trunks are automatically connected as a Remote

Access trunk. They do not use ARAC access codes.

ARAC - This command is used when a TIE Line or DID line will serve as a Remote Access to the

PBX line. A DID call will pulse into the system with digits that resemble a station number. That station

number is assigned as the REMOTE ACCESS TO SYSTEM access code.

ARRC - Allow trunk-to-trunk connection between the Remote Access route and to those outgoing

routes this feature will access. Assign using ARI-D-RES, Direct Connection.

STEP 10: ACFR - Allow the types of incoming calls listed in the Call Class Index (CCI) LDN, CCSA, that will

be connected to Remote Access. REMOTE ACCESS TO SYSTEM is Transfer Service Feature Index

(TSFI) number 7.

STEP 11: ASTD - Assign the state translation data: STM=4, SYS=0, ST=1 (Remote Access to PBX In Service).

FCCS Programming

This data setting describes only the additional or replacement commands used to activate FCCS

services. When used as an FCCS feature, these commands replace the non-network commands (for

example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending

on the node.

ARTDN - Assign the Remote Access route as shown below:

DIRECT INWARD DIAL (WINK START):

ARRCN - Allow trunk-to-trunk connection between the Remote Access route and to those outgoing

routes this feature will access. Assign using ARI-D-RES, Direct Connection.

When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required

in addition to ASYDL or ASYDN.

Remote Access to System

NEAX2400 IPX Feature Programming Manual

NDA-24297, Issue 1