NEC NEAX2400 IPX Programming Manual page 852

Feature programming manual

Hide thumbs Also See for NEAX2400 IPX:

Table of Contents

Interactions (cont'd)

The station will continue to ring, even as the call recalls to the Attendant Console. When conference is

allowed and a conference card is programmed and installed, if the station should answer at the same time

the Attendant answers the recalling call, a three-way conversation will then take place. The Attendant can

press the SRC, DEST, or TALK keys to achieve the desired conversation, or press the RELEASE key to

get out of the conversation.

Station calls extended by the Attendant to another station within the same system (node) will recall to the

Attendant. Station calls extended by the Attendant over CCIS will not recall. Trunk calls will recall in both

ASYD - System Data 1, Index 145.

Timer Class 1 = 2 seconds. For normal operation, assign 00H. [RAM data is 94H.] Any call that uses

AUTOMATIC RECALL, keeps one of the Attendant Console switched loops busy. Since there are six

loops per Attendant Console, the maximum use of this feature is limited to that number.

AUTOMATIC RECALL interval (normally set for 30 seconds) is a system option (System Data 1,

Index 145), and can be varied from two seconds to two minutes in increments of two seconds.

System Data 1, Index 73, Bit 6. Is the dialed number display for AUTOMATIC RECALL in service?

0/1: No/Yes.

System Data 2, Index 2, Bit 5.

Must be programmed as data "1". Attendant Loop Release in service.

NEAX2400 IPX Feature Programming Manual

NDA-24297, Issue 1

Automatic Recall - CCIS