Table of Contents
Advertisement
A-18
A-18
General Description
This feature is an adjunct to STATION MESSAGE DETAIL RECORDING [S-10], which provides a user with the
capability to enter a cost-accounting or client-billing code (up to 10 digits) into the system before dialing a long
distance number.
Operating Procedure
To enter an ACCOUNT CODE
1.
Lift the handset; receive dial tone.
2.
Dial the feature access code; receive service set tone.
3.
Dial the ACCOUNT CODE (up to 10 digits).
4.
Receive dial tone and dial the called number.
Feature access code - Access code for ACCOUNT CODE entry will be a maximum of 3 digits.
Note:
To enter an ACCOUNT CODE after an AUTHORIZATION CODE [A-20]
1.
Lift the handset; receive dial tone.
2.
Dial the feature access code for AUTHORIZATION CODE and receive service set tone.
3.
Dial the AUTHORIZATION CODE (up to 10 digits) and receive second service set tone.
4.
Dial the ACCOUNT CODE and receive dial tone.
5.
Dial the called number.
Service Conditions
1.
The maximum number of digits for an ACCOUNT CODE is 10. There is no limitation to the number of
account codes used per system.
Note:
Service set tone after the feature access code can be eliminated by system data. System data is common for
ACCOUNT CODE, AUTHORIZATION CODE [A-20] and FORCED ACCOUNT CODE [F-7].
2.
A user can enter an ACCOUNT CODE of fewer digits than the maximum length defined and indicate the
end of entry by pressing the # key.
3.
The user may decide if ACCOUNT CODE follows the AUTHORIZATION CODE (per tenant basis).
4.
ACCOUNT CODE dialing is also effective while in CONSULTATION HOLD [C-17]. A special dial tone
is received after entering the ACCOUNT CODE.
5.
Stations are assigned this feature via Class of Service.
6.
ACCOUNT CODES can be output in the SMDR record for calls handled with OUTGOING TRUNK
QUEUING [O-2] and OFF-HOOK QUEUING [O-7].
Interactions
1.
If FORCED ACCOUNT CODES [F-7] are used, ACCOUNT CODES, by definition, are not.
2.
ACCOUNT CODE is also effective while in CONSULTATION HOLD [C-17]. A special dial tone is
received after the ACCOUNT CODE.
3.
When using this feature on a single-line telephone or D
SYSTEM, GROUP, INDIVIDUAL or SPEED CALLING-ONE TOUCH (D
4.
ACCOUNT CODES cannot be entered by a station upon answering an incoming trunk call. The
ACCOUNT CODE can be entered by the Attendant Console before extending the call to a station.
Page 24
Account Code
Account Code
term
, the user can use the SPEED CALLING-
term
) to complete the call.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
