NEC NEAX2400 IPX Programming Manual page 503

Feature programming manual
Hide thumbs Also See for NEAX2400 IPX:
Table of Contents

Advertisement

L-30
Service Conditions (cont'd)
Note 3:
When forwarding destination for this feature is not assigned, busy tone is sent.
10.
When assigning a forwarding destination number for Night Mode using ALDNN command, the maximum
16 digits can be programmed by using TYPE = 1 (Station Number) / 2 (DC). If the user requires digit
number greater than 16 or more, assign an Abbreviated Digit Number (ADC) of the forwarding
destination, preprogrammed by ASPD command, by using TYPE = 3 (Abbreviated Digit Number).
11.
The user can assign different forwarding destination numbers (Telephone Number) to each LDN.
The maximum number of telephone numbers that can be programmed in the system is 65,535.
Note 4:
12.
The user must restrict tandem connection that release-guard signal cannot be detected by tandem-office.
13.
Whether special transmission tone is sent or not while number data is transmitted depends on System Data
1 Index 6 Bit 0.
14.
LDN call terminated from MFC Line cannot be forwarded to MFC Line.
15.
Forwarding features (except for following) are available for forwarding destination:
CALL FORWARDING-ALL CALLS
CALL FORWARDING-BUSY LINE
CALL FORWARDING-DON'T ANSWER
CALL FORWARDING-ALL CALLS-OUTSIDE
CALL FORWARDING-BUSY LINE-OUTSIDE
CALL FORWARDING-DON'T ANSWER-OUTSIDE [C-74]
CALL TRANSFER-ATTENDANT
16.
NIGHT CONNECTION FIXED [N-1] or TRUNK ANSWER FROM ANY STATION [T-8] is available
while the destination is in the following states:
Forwarding destination is not assigned by ALDNN command.
CALL FORWARDING-BUSY LINE [C-2] to ATTCON is set.
CALL FORWARDING-ALL CALLS [C-5] to ATTCON is set.
CALL FORWARDING-INTERCEPT/ANNOUNCEMENT [C-25] is set.
CALL FORWARDING-ALL CALLS-OUTSIDE [C-28] is set.
CALL FORWARDING-BUSY LINE-OUTSIDE [C-60] is set.
LDN call originated from MFC line is forwarded to MFC line.
FCCS link is all busy/make-busy/locked out.
Trunk/Route is all busy.
Toll is restricted.
Line is locked out.
NIGHT CONNECTION FIXED [N-1] takes priority over TRUNK ANSWER FROM ANY STATION [T-8].
Note 5:
17.
When forwarding destination (including CCIS line) is not set, busy or restricted, Busy Tone or Reorder
Tone is sent.
18.
LDN NIGHT CONNECTION [N-1] is available for connections shown in table below:
INCOMING
Page 460
LDN Night Connection - Outside
CCIS TRUNK
Possible
CCIS TRUNK
Possible
DID TRUNK
Possible
MFC TRUNK
[C-28] to ATTCON
[C-2] to ATTCON
[C-3] to ATTCON
[C-28]
[C-60]
[C-10]
OUTGOING
DOD TRUNK
MFC TRUNK
Possible
Possible
Possible
NEAX2400 IPX Feature Programming Manual
Possible
Possible
Impossible
NDA-24297, Issue 1

Advertisement

Table of Contents
loading

Table of Contents