Table of Contents
Advertisement
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASYDN - These data must be set to the NCN.
System Data 1, Index 69, b7. Enable Multiple Call Forwarding-Busy Line/Don't Answer/All Calls. 0/
1=Out of Service/In Service. Index 5, b1-b3. Assign the number of time for forwarding.
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note:
in addition to ASYDL or ASYDN.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Multiple Call Forwarding - Busy Line
Note
M-24
Page 497
Advertisement
Table of Contents
