Table of Contents
Advertisement
M-19D
Service Conditions (cont'd)
5.
Messages can be displayed only when the station is on-hook. A message may be cleared by displaying the
message and pressing the "*" or "#" key on the called D
6.
A message is cleared when it is obtained via the MSG key.
7.
Messages cannot be cleared by the message sender.
8.
A second message sent by the same calling D
applies to the third and fourth messages.
9.
If a message is returned to an unattended station, the telephone number may be stored as a LAST
NUMBER DIALED [L-6], SAVE AND REPEAT [S-24], or a new MESSAGE REMINDER may be sent.
10.
Messages are sent to the forwarded-to station, which is set by CALL FORWARDING - ALL CALLS [C-
5] or CALL FORWARDING - BUSY/DON'T ANSWER [C-2, 3].
11.
Messages cannot be sent to a UCD [U-1] station when all stations in the UCD group are busy.
12.
Messages are sent to a dialed station when all stations in a Station Hunting (Circular) group are busy.
13.
If CALL WAITING - ORIGINATING [C-31] automatic operation is in service, it will supersede this
service. If a third station calls and receives busy tone, MESSAGE REMINDER - D
14.
A maximum of 32 digits can be saved at the called party.
15.
To utilize the telephone number of the calling station, assign SYS1, Index 641, b0=1 by the ASYDN
command.
16.
For the FCCS network, when using this feature with a D
recommended:
term
If the D
Series III is accommodated on one of these circuit cards, a telephone number is indicated by the
Note:
first eight digits only.
17.
The setting station in the FCCS network must provide telephone numbers for this feature.
18.
Message (telephone number) is cleared by the circuit card initialization or the system initialization.
19.
Memory clear is necessary before reprogramming of station data and before using Follow Phone service.
Interactions
If CALL WAITING-ORIGINATING [C-31] automatic operation is in service, it will supersede MESSAGE
term
REMINDER-D
. If a third station calls and receives busy tone, MESSAGE REMINDER-D
Programming
For Single-Line Sets
STEP 1:
ASYD - System Data 1, Index 17, Bit 0.
Single-line stations able to use VOICE CALL [V-2D] and MESSAGE REMINDER features to a D
while hearing ringback tone?
0/1: Restricted/Allowed.
STEP 2:
ASFC - Assign the single-line stations a feature class that allows SFI: 53, Message Reminder.
Page 484
Message Reminder - D
FUNCTION NAME
16ELC
DAI
2DAI
DRU
term
term
's key pad.
term
is registered as a second unique message. The same
term
Series E, the following circuit cards are
CIRCUIT CARD
PA-DAIG, PA-DAIH, PA-DAIJ
NEAX2400 IPX Feature Programming Manual
term
cannot be set.
PA-16ELCJ
PA-2DAIK
term
can be set.
NDA-24297, Issue 1
term
Advertisement
Table of Contents
