NEC NEAX2400 IPX Programming Manual page 897

Feature programming manual
Hide thumbs Also See for NEAX2400 IPX:
Table of Contents

Advertisement

C-50
Service Conditions (cont'd)
2.
The THREE-WAY CALLING [T-2] feature allows a maximum of three parties on one connection. The
three parties can be:
Three stations,
Two stations and one trunk, or
One station and two trunks.
3.
The maximum number of simultaneous THREE-WAY CALLING [T-2] connections is dependent upon
the quantity of conference trunks (Route 909s) programmed in the system.
4.
Reorder tone is returned to the transferring station under the following conditions:
a.) The transferring station is restricted.
b.) The transferring station dials an unequipped number or the route is restricted.
c.) The transferring station dials an invalid first digit.
5.
If a station is in an established THREE-WAY [T-2] conference, it cannot activate any features. If the
station switch hook flashes to activate a feature, the switch hook flash is ignored and the THREE-WAY
conference remains connected.
6.
The user who has transferred the call can hang up before the called party answers the call. The called party
will continue to ring and recall is not effected.
7.
Outgoing calls with answer supervision may be transferred immediately after the call answered (no time
delay).
8.
Outgoing calls with no answer supervision can be transferred only after the time periods assigned in
ASYD, Indexes 156 or 157 have elapsed since the last digit was dialed.
9.
If a station is in CONSULTATION HOLD [C-58] or in an established THREE-WAY connection, any
attempt to override the connection using one of the following features will be denied:
ATTENDANT CAMP-ON WITH TONE INDICATION
BOSS-SECRETARY OVERRIDE
BUSY VERIFICATION
CALL WAITING-TERMINATING
EXECUTIVE RIGHT-OF-WAY
10.
A station engaged in either a SERIAL CALL - CCIS [S-52] or SUPERVISORY CALL - CCIS [S-73] is
not allowed CALL TRANSFER-ALL CALLS - CCIS.
Interactions
1.
This feature is denied whenever the transferring station is engaged in any state other than a simple two-
party connection.
2.
See TRUNK-TO-TRUNK CONNECTION
transferred off network.
3.
Features that cannot be activated while a user has a party in CONSULTATION HOLD [C-58] are:
EXECUTIVE RIGHT-OF-WAY
TRUNK ANSWER FROM ANY STATION (TAS)
CALL BACK (Activate or Cancel)
CALL PICKUP-DIRECT
CALL FORWARDING (Activate or Cancel)
OUTGOING TRUNK QUEUING Cancel
SPEED CALLING-STATION Entry
MESSAGE REMINDER
Page 854
Call Transfer - All Calls - CCIS
[T-10]
[A-1] [A-45]
[B-5]
[B-3] [B-9]
[C-12]
[E-1] [E-8]
for additional programming if the call is to be
[E-1][E-8]
[T-8]
[C-1] [C-44]
[C-30]
[C-2,3,5] [C-45,46,47]
[O-2] [O-12]
[S-21]
[M-19D] [M-34]
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1

Advertisement

Table of Contents
loading

Table of Contents