Table of Contents
Advertisement
Service Conditions (cont'd)
• when the outgoing trunks are all busy (if Tandem Trunk Queuing service is set, the service is
activated).
20.
After the second announcement is sent out, whether to allow dialing of the next number or to release the
call automatically can be selected on a system basis.
21.
The announcement can be either 16, 32, or 60 seconds, depending on the key setting of the announcement
trunk (PA-4DATA). The announcement trunk should always be connected in single connection.
22.
When the caller attempts trunk call origination by this service and encounters restriction, the class change
service via authorization code dialing is not available.
23.
The following services are denied toward a line or trunk involved in Serial Call:
CALL FORWARDING - ALL CALLS
CALL FORWARDING - BUSY LINE
CALL FORWARDING - DON'T ANSWER
CALL PICKUP - DIRECT
CALL PICKUP - GROUP
CALL WAITING - ORIGINATING
CALL WAITING - TERMINATING
STATION HUNTING - CIRCULAR
STATION HUNTING - SECRETARIAL
STATION HUNTING - TERMINAL
24.
When the called station via Serial Call is busy, STEP CALL [S-13] is not available.
25.
When the call is extended to a trunk, the call is charged to the incoming trunk (the caller).
Programming
STEP 1:
ASYD - System data 1, index 007, bit 5 = 0/1: when dialing a vacant level, unused number, timeout,
recall, or restricted connection, the caller will be (0) able to redial / (1) disconnected.
System data 1, index 435, bit 0 = 0/1: Serial Call in service No/Yes.
System data 1, index 435, bit 1 = 0/1: after pre-pause timer, recall/disconnect.
System data 1, index 435, bit 2 = 0/1: when recalling, the service will end/continue.
STEP 2:
AKYD - FKY 84 = Serial Call.
STEP 3:
ADSL - Assign SCALL key; Assign SN=4 (Communication in Progress) and FKY=84 (Serial Call).
This command is used for assigning a function to each soft key.
STEP 4:
AAED - EQP 34 (Auto Attendant first announcement) C = 0, R = 1, A = 1, M = 0.
EQP 35 (Auto Attendant second announcement) C = 0, R = 1, A = 1, M = 0.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
AAEDN - EQP 34 (Auto Attendant first announcement) C = 0, R = 1, A = 1, M = 0.
EQP 35 (Auto Attendant second announcement) C = 0, R = 1, A = 1, M = 0.
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note:
in addition to ASYDL or ASYDN.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Serial Call - D
Note
term
[C-5]
[C-2]
[C-3]
[C-30]
[C-7]
[C-31]
[C-12]
[S-7]
[S-8]
[S-9]
S-127
Page 727
Advertisement
Table of Contents
