Table of Contents
Advertisement
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASPAL - This data must be set to the node calling the attendant.
Assign the FPC of the node which accommodates the called attendant console. This must be assigned
after designating SID = 37, 38, 39.
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note:
in addition to ASYDL or ASYDN.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Note
Priority Call
P-9
Page 589
Advertisement
Table of Contents
