Table of Contents
Advertisement
Service Conditions (cont'd)
6.
Traffic measurement duration time is designated for more than one hour. If the traffic measurement
duration time is not designated, the measurement is performed indefinitely until a stop command is entered
on the MAT [M-18].
Station Peg Count
Route Peg Count
ATT Peg Count - Incoming
ATT Peg Count - Answer
Interactions
If the system is reset, traffic measurement requests are no longer in service.
Programming
To Order PEG COUNTS
STEP 1:
ASYD - System Data 1, Index 47, bit 7 = 1.
STEP 2:
ASTD - STM:7, STS:0, ST:1.
STEP 3:
ATRF - Assignment of Traffic Measurement Order
TYPE:
INTERVAL: Output Interval must be assigned in units of 10 minutes. Available range is from 30-120
minutes or "0" must be assigned.
FROM-TO-: Measurement to be designated.
TIME:
TYPE:
To Display PEG COUNT Information
STEP 1:
DTF1 - Display of Traffic Data 1
TYPE:
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
PEG COUNT
Type of Traffic Measurement
Output Time
1:
Terminal Traffic Measurement
2:
Route Traffic Measurement
3:
Station Peg Count
4:
Attendant Console Peg Count
5:
Route Peg Count
6:
Service Peg Count
8:
UCD Route Peg Count
9:
UCD Group Peg Count
10:
UCD Station Peg Count
11:
CCIS Traffic Count
Type of Traffic Measurement
1:
Terminal Traffic
2:
Route Traffic
3:
Station Peg Count
4:
ATT Peg Count
5:
Route Peg Count
Peg Count
NEAX2400 IPX
TN = 1-255
RT = 1-255
TN = 1-255
ATT = 1-16
P-7
Page 585
Advertisement
Table of Contents
