Table of Contents
Advertisement
E-18
Service Conditions (cont'd)
•
If ANI data is unassigned:
KP-1-ST
5.
An independent route is required for E911 interface.
6.
After the caller's number is sent to the distant office by E911-ANI, it takes some time until a speech path
is established.
7.
Sending data is considered to be not assigned if:
a.) Service version data specifies that Unified Number of Digits is provided,
b.) No data is assigned for Unified Number of Digits service, and
c.) Data for previous E911-ANI service is assigned
8.
After digits have been sent out, DDD seizure tone is not sent.
9.
Other interactions are the same as those of outgoing calls by MF signaling.
10.
An 8RST-K circuit card is used.
Programming
STEP 1:
ARTD - Assign RT: 4, with the following conditions set:
RT: 4
1-OSGS
6-TCL
15-LSG
74-KPPT
STEP 2:
ATRK - Assign RT 905 to LEN for TK1, TK2 (depending on register location). Assign RT 904 to
LEN for TK1, TK2 (depending on register location).
STEP 3:
AAND - Assign the following parameters:
RT:
0 (Outgoing RT number)
AT:
0 (0/1: Station/Individual Attendant)
CC:
0 (0/1: Main Central/Satellite Central) Programming is only necessary at the Main node.
COC: (Central Office code, CCIS office code, or first digit of CCIS remote station number). Use
CCIS office code.
STNL: (number of digits in caller's number)
SKIP: (number of digits to be skipped from caller's number) This strips the office code from being
sent out in front of the calling station number.
ADD: 3 (number of digits to be added to the ANI information).
DC:
753 (ANI sending number)
Note:
Using this programming, if the call was originated at remote node station number 2000, the number being
sent to the E911 Central Office would be "753-2000"
AANDE - Assign the following parameters
TN:
(1-255)
Skip:
Call Originator digit
ADD: Office Code to be added (1-10)
DC:
Office Code (1-10)
FCCS Programming
No unique programming is required for the FCCS network.
Page 344
E911-ANI Unified Number Of Digits
Information digit
:7
2-ONSG
:4
:5
7-L/T
:1
:5
19-ANI
:1
:13
75-STC
:15
3-ISGS
:7
4-INSG
8-RLP
:2
10-SMDS :1
30-PAD
:4
43-BT
77-MT
:1
NEAX2400 IPX Feature Programming Manual
:4
5-TF
:3
13-AC
:1
:1
73-KPST
:7
NDA-24297, Issue 1
Advertisement
Table of Contents
