Table of Contents
Advertisement
Programming
STEP 1:
ASYD - System Data 1, Index 5, Bit 0. Access codes for CALL FORWARDING BUSY LINE - D
and CALL FORWARDING - DON'T ANSWER [C-3] are same or separate? 0/1: Same/Separate.
System Data 1, Index 69, Bit 5, Index 69, Bit 7.
STEP 2:
ANPD - Reserve a number level for feature access and cancel. Assign for Normal (N), Hooking (H),
and BUSY (B). Assign NND in accordance with a predetermined numbering plan.
STEP 3:
ASPA - Assign an access code to CALL FORWARDING - BUSY LINE - D
to CALL FORWARDING-BUSY LINE-D
for Normal (N) service.
STEP 4:
ASFC - Assign a Service Feature Class that allows SFI = 9 to the stations that receive CALL
FORWARDING-BUSY LINE-D
STEP 5:
AKYD - For D
programmable line/feature key. Assign
STEP 6:
ADSL - Assign SN=3 (Called Station is Busy) and FKY=1 (Call Forwarding - Busy Line; FDB)
This command is required only for assigning the function to each soft key.
STEP 7:
ATNR - Allow tenant-to-tenant connection for Inter and Intra-tenant connections. Assign Tenant
Restriction Index (TRI) = 1. For this feature to be set, assign Inter and Intra-Tenant connection TRI =
3 from the Attendant Console. This allows a station in one tenant group to be call forwarded to a
station in the same or different tenant group. Also assign TRI = 0, station-to-station calling.
STEP 8:
ACFO - For tenant-wide CALL FORWARDING-BUSY LINE - D
calls, assign CF = 1 for a destination (CFI) of either the Attendant Console or a station.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ASYDL - This data must be assigned to the node set Call Forwarding service.
System Data 1, Index 640: Assign the FPC of the node providing the attendant console.
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
Note 1:
in addition to ASYDL or ASYDN.
The data of the ASFC command is assigned to the node set Call Forwarding service.
Note 2:
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Forwarding - Busy Line - D
term
term
sets, CALL FORWARDING-BUSY LINE-D
Note 1
term
cancel SID = 11. Assign Connection Status Index (CI)
.
Function:CALL FORWARDING-BUSY LINE [1].
Type:
term
term
entry, SID = 10 and
term
may be assigned to a
term
of incoming DID and DIT
C-2D
term
Page 119
Advertisement
Table of Contents
