Table of Contents
Advertisement
S-99
Operating Procedure (cont'd)
When the destination is an ATTENDANT CONSOLE, the D
When the destination is an outside trunk, the D
2.
To monitor the assigned data for station-to-station calls:
a.) Confirm that the PAGE key LED on the D
PAGE key to turn it on.)
b.) While the D
BUSY LINE or DON'T ANSWER feature key.
When the destination is a station, the D
When the destination is an ATTENDANT CONSOLE, the D
To set Call Forwarding from the Attendant Console
1.
Setting Call Forwarding for an incoming call from a station:
a.) Press an idle Loop key and dial the FORWARD, FORWARD-BY, or FORWARD-DA access
code for an incoming call from a station; receive special dial tone.
b.) Dial the Tenant Number (2 digits) of the originating station, the originating telephone number,
and the desired target telephone number, receive service set tone.
c.) Press the RELEASE key.
2.
Setting Call Forwarding for an incoming call from an outside party:
a.) Press an idle Loop key and dial the FORWARD, FORWARD-BY, or FORWARD-DA access
code for an incoming call from an outside party; receive special dial tone.
b.) Dial the Tenant Number (2 digits) of the originating station, the originating telephone number,
and the desired target telephone number; receive service set tone.
c.) Press the RELEASE key.
Page 718
Split Call Forwarding
FWD SET OPR
(Time Display)
FORWARD
(Time Display)
term
is in the idle state (on-hook), press the CALL FORWARDING - ALL CALLS/
FORWARD
(Time Display)
FWD SET OPR
(Time Display)
term
displays:
XXXXX
term
is illuminated. (If it is not illuminated, press the
term
displays:
XXXXX
term
displays:
term
displays:
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
