Table of Contents
Advertisement
P-10
Programming (cont'd)
System Data 1, Index 74, Bits 0 & 3. Assign the cancel timer for unanswered page. Assign data 00H
for 30 seconds.
(0-F + 1) x 30 = Cancel Timer.
System Data 2, Index 1, Bits 0 & 1. Consultation Hold allowed or denied. 00: Denied; 01: Originating
and Terminating Calls allowed; Tandem Call Denied; 11: All calls allowed.
STEP 2:
ARTD - Assign the paging route as shown below:
RT: 1
1-OSGS
8-RLP
STEP 3:
ATRK - Assign the LENs, Paging Trunk Route Number, Trunk Number, and Tenant Number.
STEP 4:
MBTK - Assign the Make Idle status to the Paging trunks.
STEP 5:
ANPD - Reserve levels for trunk access and for PAGE answer and cancel codes. Assign the trunk
access level for a Connection Index (CI) of Normal (N) and Hooking (H) service. Number of
Necessary Digits is usually 1 or 2 (maximum 3 digits). Busy Lamp Field is not activated.
If the PAGE answer and cancel codes reside in a level reserved for features, then assign according to a
predetermined numbering plan. If the PAGE answer and cancel codes reside in a separate level, then
assign for a CI of Normal (N) only. The number of Necessary Digits is usually two, and the Busy
Lamp Field is off.
STEP 6:
ASPA - Assign Paging Route access code. Type of Service, SRV = OGC (Outgoing Call). Assign the
proper route number that is associated with this Paging trunk access code. Assign for CI = Normal (N)
and Hooking (H).
Assign the PAGE answer and cancel access code. Type of Service, SRV = PAGA (Paging Answer)
and SRV = PAGC (Paging Cancel). Assign the proper route number that is associated with this access
code. Assign for CI = Normal (N).
STEP 7:
ARSC - Allow RRI: 2 & 3 access to this route for the RSCs assigned to stations given access to the
paging routes. Allow RRI: 0 & 1 on the incoming route to be transferred to the RSCs given access to
the page answer.
STEP 8:
ASFC - Assign station to receive PAGING TRANSFER a Service Feature Class that allows SFI = 38.
This allows a station to dial PAGE answer codes.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ALRTN - This data must be assigned to the NCN. Assign the logical route number to the physical
route.
STEP 2:
ANPDN - This data must be assigned to the NCN. Reserve a number level for service feature access
and cancel.
STEP 3:
ASPAN - This data must be assigned to the NCN. Assign the access code for Paging Transfer.
STEP 4:
ARSCN - This data must be assigned to the NCN. Release the restriction between the announcement
trunk and the station.
STEP 5:
ARRCN - This data must be assigned to the NCN. Release the restriction between the terminating
trunk and the announcement trunk.
Page 592
Paging Transfer
:2
2-ONSG
:3
:2
15-LSG
:1
Note 1
5-TF
:1
6-TCL
NEAX2400 IPX Feature Programming Manual
:8
7-L/T
:1
NDA-24297, Issue 1
Advertisement
Table of Contents
