NEC NEAX2400 IPX Programming Manual page 531

Feature programming manual
Hide thumbs Also See for NEAX2400 IPX:
Table of Contents

Advertisement

M-23
M-23
Message Waiting Lamp Setting - Attendant
General Description
This feature permits an ATTENDANT CONSOLE [A-3] to set or cancel a Message Waiting indication on a station
provided with this feature.
Operating Procedure
To set a Message Waiting indication
1.
Press an idle loop key.
2.
Dial the Message Waiting set code (up to 3 digits); receive special dial tone.
3.
Dial the telephone number; receive service set tone.
4.
Message Waiting indication is set.
5.
Press the RELEASE key to return to an idle condition.
To cancel a Message Waiting indication
1.
Press an idle loop key.
2.
Dial the Message Waiting cancel code (up to 3 digits); receive special dial tone.
3.
Dial the telephone number; receive service set tone.
4.
Message Waiting indication is cancelled.
5.
Press the RELEASE key to return to an idle condition.
Service Conditions
1.
The Message Waiting lamp on a single line telephone or a D
2.
When Message Waiting is set to a D
3.
Message Waiting cannot be set when the ATTENDANT CONSOLE [A-3] is in a consultation condition
with a station or trunk.
4.
An Attendant attempting to set Message Waiting to a station where Message Waiting has previously been
set, will receive busy tone.
5.
In a MULTIPLE CONSOLE OPERATION [M-4], if Message Waiting is set by one ATTENDANT
CONSOLE [A-3], it can be cancelled by another.
6.
Message Waiting indications are cleared when the system is initialized.
Page 488
Message Waiting Lamp Setting - Attendant
term
station, the LCD display indicates:
(Time Display)
term
will be lit when this feature is activated.
MW
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1

Advertisement

Table of Contents
loading

Table of Contents