Table of Contents
Advertisement
E-26
Service Conditions (cont'd)
b.) PA-16ELCJB-B, SW10, Element 1 = OFF:A D
Even when Element 1 of SW10 is ON, data programming for this feature (Multiple Lines beyond different
Note:
IMGs) is possible. However, the data does not become effective until the switch is manually placed to OFF.
term
3.
A D
cannot register a Sub Line accommodated on an ELC card in a different node (having a different
CPU). Therefore, if your system is an IPX-U (16-IMG) type, this feature must be programmed on a node
basis.
4.
Three kinds of lines can appear on a D
• MY Line (ML):This line is associated with the extension number assigned to the port on the interface
circuit.
• Prime Line (PL):This line is given priority for outgoing and incoming calls. The prime line is
automatically seized when going off-hook.
• Sub Line (SL):This line designates any other line appearing on a D
prime line, unless differentiated in system data programming.
5.
A maximum of 32 PA-16ELCJB-B cards (a total of 512 ports) can be used for this feature (Multiple Lines
beyond different IMGs), per node.
Note:
This is not the case if the Multiple Lines are programmed in a single IMG.
6.
If the system is a 1-IMG type, this feature is not available.
7.
A virtual line (Software Line Appearance [S-33]), single line telephone or D
subline.
8.
To use this feature, flag "1" to the ASYD command, SYS 1, Index 321, b0.
9.
When KD = 1 (Intercom) or KD = 2(DSS Key) is assigned on the AKYD command, this service is not
available. Be sure to assign KD = 0 (Line).
Interactions
1.
This feature is effective with the following services:
Call Hold
Call Forwarding - Busy Line
Call Forwarding - Don't Answer
Call Forwarding - All Call
Voice Call
Call Pick Up - Group
Boss - Secretary Override - D
Boss - Secretary - Message Lamp Control
Boss - Secretary Transfer
Station Hunting - Circular
Station Hunting - Secretarial
Station Hunting - Terminal
Three Way Calling
Call Transfer
Consultation Hold - All Calls
Blind Transfer To Attendant
Blind Transfer To Station
Page 346
Expanded Multiple Line Operation - D
term
line/feature key:
term
term
term
, accommodated on this card, and the other
Lines (other analog telephone/D
different IMGs (but in the same node). For more
details on the PA-16ELCJ-B circuit card, refer to the
NEAX2400 IPX Circuit Card Manual.
term
[C-6, 6D]
[C-2, 2D]
[C-3, 3D]
[C-5, 5D]
[V-2]
[C-7, 7D]
[B-5D]
[B-8]
[B-11]
[S-7]
[S-8]
[S-9]
[T-2, 2D]
[C-11, 11D]
[C-17, 17D]
[B-17]
[B-18]
NEAX2400 IPX Feature Programming Manual
term
) can be in
. The MY Line will serve as a
term
can be assigned as a
Note
Note
Note
NDA-24297, Issue 1
Advertisement
Table of Contents
