Table of Contents
Advertisement
M-26
Operating Procedure (cont'd)
4.
The called station will be able to receive a message by dialing "0", or by a computer terminal by entering
his/her identification number.
5.
The external CPU, upon receiving retrieved message information, will transmit a data record requesting
the NEAX2400 IPX to extinguish the Call Indicator Lamp of the corresponding station.
Service Conditions
1.
The call type is sent to the external CPU via the MCI interface, this call record will pertain to the following
services:
ATTENDANT CAMP-ON
AUTOMATIC RECALL
CALL FORWARDING - DON'T ANSWER
CALL FORWARDING - BUSY LINE
CALL FORWARDING - ALL CALLS
Call returned from Hold
CALL TRANSFER - ALL CALLS
CENTRALIZED ATTENDANT SERVICE (CAS)
DIAL ACCESS TO ATTENDANT
DID to the Specific UCD Group
DIT to the Specific UCD Group
Intercept Call to the Attendant
INTER-POSITION TRANSFER
LDN call
OFF-HOOK ALARM
Recall
Recall from a Series Call
Series Call Re-Entry
Tandem Transferring/Hold Entry
Available for interoffice station transfer calls only.
Note:
NEAX2400 IPX
UCD
MESSAGE
CENTER
INTERFACE
2.
The NEAX2400 IPX MESSAGE CENTER INTERFACE [M-26] can control the display of a D
Message Indication; MW in a Message Center application.
3.
If an ATTENDANT CONSOLE [A-3] calls a UCD [U-1] group directly, for Feature 2, the NEAX2400
IPX will not generate a call record to the MCI.
Page 504
Message Center Interface
Note
MESSAGE CENTER
MESSAGE
CENTER
COMPUTER
[A-1]
[A-8]
[C-3]
[C-2]
[C-5]
[C-11]
[C-20]
[D-2]
[I-5]
[O-6]
ANALOG
NEAX2400 IPX
STATION
LINE
UCD
MESSAGE
CENTER
INTERFACE
NEAX2400 IPX Feature Programming Manual
VOICE MAIL
SYSTEM
term
for
NDA-24297, Issue 1
Advertisement
Table of Contents
