Table of Contents
Advertisement
S-3D
S-3D
General Description
term
This feature allows a D
would normally be required.
Operating Procedure
Originating a call from a D
1.
Press the SPEED CALLING-SYSTEM (SPEED-SYS) key.
2.
Dial the abbreviated call code (maximum of four digits). The LCD displays:
3.
The call is completed.
term
4.
If the D
does not have the SPEED-SYS key, dial the SPEED CALLING-SYSTEM access code, then
the abbreviated call code.
To operate from a SPEED CALLING-ONE TOUCH key
1.
Press a FEATURE key, then a One Touch-Speed Calling key. The LCD displays previously stored digits.
2.
Dial the SPEED CALLING-SYSTEM access code and the abbreviated call code.
3.
Press the FEATURE key. The LCD displays:
4.
To access, press the SPEED CALLING-ONE TOUCH D
Service Conditions
1.
SPEED CALLING-SYSTEM [S-3] codes programmed into system data are accessible to all stations with
a CLASS OF SERVICE-INDIVIDUAL [C-15] permitting speed calling.
2.
Each abbreviated call code can store a maximum of 24 digits, including access codes and pauses.
3.
The standard number of speed calling numbers stored in the NEAX2400 IPX is 1,000.
4.
Speed calling numbers are programmed via system data from the MAINTENANCE ADMINISTRATION
TERMINAL (MAT) [M-18].
5.
Stations may be denied access to SPEED CALLING - SYSTEM - D
INDIVIDUAL [C-15] assignment in system data. SPEED CALLING SYSTEM [S-3] may be allowed or
denied on either a station or tenant-wide basis.
6.
TOLL DENIAL/TOLL DIVERSION [T-6] and TOLL RESTRICTION-3/6-DIGIT [T-7] may or may not
be applied to SPEED CALLING - SYSTEM - D
7.
LEAST-COST ROUTING-3/6-DIGIT [L-5] may be provided via SPEED CALLING-SYSTEM access.
8.
When assigning the access code to the line/feature key, the abbreviated call code must be set at 2 to 4
digits.
Page 644
Speed Calling - System - D
Speed Calling - System - D
user to call frequently dialed numbers using fewer digits (abbreviated call codes) than
term
(Time Display)
Abbreviated Call Code
SPEED SET
(Time Display)
term
XXX
term
[S-26D] key.
term
term
, depending on preference.
NEAX2400 IPX Feature Programming Manual
term
via CLASS OF SERVICE-
NDA-24297, Issue 1
Advertisement
Table of Contents
