Table of Contents
Advertisement
Service Conditions (cont'd)
b.) When stations belonging to different nodes are assigned to a Hunt group, the station hunt may not
be activated in assigned order if the stations are not assigned in continuous order within a node.
First, the call is shifted to the station within the node of the Pilot station even though it is not in
consecutive order (in the node, station hunt is activated in assigned order). After all the stations in
the node are hunted, the station hunt is shifted to the next assigned station and the stations in the
node are hunted in assigned order. The station hunt continues in this way until the idle station is
found. See the following figure.
Example:
•
Station No. 1 is the pilot station. When the call encounters busy, the call is hunted in order of No. 3, No. 4 (hunted
in the node of the pilot station) to No. 2, No. 6, No. 8 (hunted in the node C that accommodates the next station in
assigned order) to No. 5, No. 7.
Node A
No.1
No.3
Pilot Station
Numbers under the stations show the assigned order.
Note:
20.
The number of the Hunt Group is unlimited.
21.
When all the stations in a Hunt Group are busy:
a.) If a call is directed to a station belonging to a group that has no Secretarial Station, the caller will
hear busy tone.
b.) If a call is directed to a station belonging to a group that has a Secretarial Station, the call will be
forwarded to the Secretarial Station. However, the caller will hear busy tone when the Secretarial
Station is also busy.
22.
When the telephone number and Physical Station Number assigned to a pilot station are identical, priority
is attached to STATION HUNTING - TERMINAL via FCCS.
23.
The incoming call terminated through FCCS link to the Station Hunt group, which is programmed by the
Physical Station Number, is not hunted.
24.
When CALL FORWARDING - ALL CALLS [C-5] has been set to the pilot station, a call directed to the
pilot station is forwarded to the designated station.
25.
When activating this feature via the FCCS network, when an incoming call to a pilot station is forwarded
by CALL FORWARDING - BUSY LINE [C-2] and the forwarded party (also a member of another
hunting group) is also busy, the resultant hunt target can be designated from the forwarding side group or
the forwarded side group. This can be specified by the ASYDN command. Refer to Programming for
further information.
26.
Phantom telephone number (PHTELN) can also be assigned to each telephone number (a maximum of 16
PHTELNs per TELN, TELNs + PHTELNS in total equal 60,000 or less). The assigned PHTELN may or
may not be the pilot number by the APHNN command setting. See details in Interactions.
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Station Hunting - Terminal
Node B
No.4
No.5
No.7
No.2
S-9
Node C
No.6
No.8
Page 663
Advertisement
Table of Contents
