NEC NEAX2400 IPX Programming Manual page 785

Feature programming manual

Hide thumbs Also See for NEAX2400 IPX:

Table of Contents

ARTD - Assign the TIE Line routes as shown below:

BOTHWAY LINES:

ATRK - Assign the LENs, TIE Line Route Number, Trunk Number, and Tenant Number.

MBTK - Assign the Make Idle status to the TIE Line trunks.

ANPD - Assign a number level for trunk access. Assign Connection Indexes, CI = N, H; Normal (N)

and Hooking (H). Number of Necessary Digits is usually 1 or 2. Busy Lamp Field is not activated.

ASPA - Assign the access code as assigned in ANPD above. Assign Connection Indexes, CI = N, H;

Normal (N) and Hooking (H). Type of Service, SRV = OGC (Outgoing Call), Outgoing Trunk. Assign

the route number associated with this access code.

ARSC - The Route Restriction Class must be constructed to allow the station access to the involved

FCCS Programming

This data setting describes only the additional or replacement commands used to activate FCCS

services. When used as an FCCS feature, these commands replace the non-network commands (for

example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending

on the node.

ARTDN - Assign the TIE Line routes as shown below:

BOTHWAY LINES:

ANPDL - Assign a number level for trunk access. Assign Connection Indexes, CI = N, H; Normal (N)

and Hooking (H). Number of Necessary Digits is usually 1 or 2. Busy Lamp Field is not activated.

ASPAL - Assign the access code as assigned in ANPD above. Assign Connection Indexes, CI = N, H;

Normal (N) and Hooking (H). Type of Service, SRV = OGC (Outgoing Call), Outgoing Trunk. Assign

the route number associated with this access code.

ARSCN - The Route Restriction Class must be constructed to allow the station access to the involved

TIE Line Access

NEAX2400 IPX Feature Programming Manual

NDA-24297, Issue 1