Table of Contents
Advertisement
A-29
Interactions (cont'd)
6.
If ASPA, SRV: LCR (Least Cost Route Selection) / LCRS (Register Sender LCR) AH parameter is
assigned as data "1", the request for an AUTHORIZATION CODE is determined by the ARSC
assignment of the station in relationship to the route chosen. For AUTHORIZATION CODE - TIE LINE
INCOMING ROUTES, no RSC is assigned against the incoming TIE Line, therefore,
AUTHORIZATION CODEs are always required. Trunk connection will be determined against the RSC
of the dialed code.
term
7.
When a D
AUTHORIZATION CODE will be recorded if previously dialed.
8.
The AMND command determines the length of AUTHORIZATION CODEs based on the first digit.
9.
AUTHORIZATION CODEs are recorded by STATION MESSAGE DETAIL RECORDING [S-10].
10.
AUTHORIZATION CODEs cannot be entered by the Attendant Console.
11.
PEG COUNTS [P-7] of invalid AUTHORIZATION CODEs are not available.
12.
AUTHORIZATION CODEs can be dialed by a user, when establishing a CONSULTATION HOLD
[C-17] connection.
13.
For Procedure 2, LCR(S) must be provided.
14.
For senderized TIE Lines, see UNIVERSAL SENDER [U-3]. Also, the ANND command must be
programmed for senderized TIE Lines. If other services, such as, STATION MESSAGE DETAIL
RECORDING [S-10] and LEAST-COST ROUTING [L-5], the AMND command will be programmed.
If digit translation is required, go to the ASTP and AOSP command.
15.
MISCELLANEOUS TRUNK RESTRICTION [M-3]. Restrictions to TIE trunks are determined by the
Route Service Class (RSC) assigned to the AUTHORIZATION CODE.
Programming
STEP 1:
ASYD - System Data 1, Index 4, Bit 4 = 1: Temporary Class Conversion is required.
System Data 1, Index 12. If Index 12 = 0, no Checksum method is used, and Indexes 13 and 14 are
ignored, regardless of their assignments. Each Bit in Index 12 directly correlates to a digit in the
AUTHORIZATION CODE assigned in AATC, and will determine the first digit of the Checksum
method. For this example, 26428 has been assigned as the AUTHORIZATION CODE in AATC. Pick
any Bits, 0 - 4, and flag those Bits as data 1.
Note:
Bit 0 - 7 may be used when 8-digit AUTHORIZATION CODES are assigned in the AATC command
AATC
SYS1, IN12
DESIGNATION
System Data 1, Index 13. Each Bit in Index 13 directly correlates to a digit in the AUTHORIZATION
CODE assigned in AATC, and will determine the second digit of the Checksum method. Pick any Bits
0 - 4, but not the same combination of Bits as picked in Index 12.
AATC
SYS1, IN13
DESIGNATION
Page 38
Authorization Code - Tie Line Incoming Routes
user initiates the LAST NUMBER CALLED - D
BIT 4
8
0
d4
BIT 4
8
1
d4
BIT 3
BIT 2
2
4
1
0
d3
d2
BIT 3
BIT 2
2
4
0
0
d3
d2
term
[L-6D] feature, the
BIT 1
6
0
d1
BIT 1
6
1
d1
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
.
BIT 0
2
1
d0
BIT 0
2
0
d0
Advertisement
Table of Contents
