Table of Contents
Advertisement
S-99
Operating Procedure (cont'd)
To set SPLIT CALL FORWARDING using D
To set Call Forwarding from an individual station (D
1.
Setting Call Forwarding for an incoming call from a station:
a.) Confirm that the PAGE* (One-touch changeover) lamp is on; if the lamp is off, turn the lamp on
by pressing the PAGE key.
b.) Lift the handset or press the SPEAKER key; receive dial tone.
c.) Press the FORWARD, FORWARD-BY, or FORWARD-DA key; receive special dial tone.
d.) Dial the number of the desired target station; receive service set tone. The following is displayed
on the LCD, when the destination is a station:
When the destination is an ATTENDANT CONSOLE, the D
When the destination is an outside trunk, The D
The FORWARD, FORWARD-BY, or FORWARD-DA lamp turns on.
e.) Replace the handset or press the SPEAKER key. *PAGE feature key is a paging button for
SPEED DIALING - One-Touch - D
2.
To set Call Forwarding for an incoming call from an outside party:
a.) Confirm that the PAGE (One-Touch Changeover) lamp is off; if the lamp is on, turn the lamp off
by pressing the PAGE key.
b.) Lift the handset or press the SPEAKER key; receive dial tone.
c.) Press the FORWARD, FORWARD-BY, or FORWARD-DA key; receive special dial tone.
d.) Dial the number of the desired target station; receive service set tone. The following is displayed
on the LCD when the destination is a station:
When the destination is an Attendant Console, the LCD displays:
Page 716
Split Call Forwarding
term
feature key
FORWARD SET
(Time Display)
FWD SET OPR
(Time Display)
FORWARD SET
(Time Display)
term
FORWARD SET
(Time Display)
FWD SET OPR
(Time Display)
term
)
XXXXX
term
term
displays:
[S-26D], (FKY = 55).
XXXXX
NEAX2400 IPX Feature Programming Manual
displays:
NDA-24297, Issue 1
Advertisement
Table of Contents
