System Data All Clear (Cm00/Cmec) - NEC UNIVERGE SV8300 Pc Programming Manual

System Data All Clear (CM00/CMEC)

Execute System Data All Clear on the SV8300 in the following steps:
STEP1: Click the [1] button [Quick Setup] screen.
The [1. All-Clear of System Data] screen is displayed in the work window.
STEP2: Set the [SENSE] switch to "E" on the CPU blade mounted in the SV8300.
STEP3: Press the [RESET] button on the CPU blade to reset.
Press the CPU blade [RESET] button and the lamps will change in their states as described
below.
Change
Press the [RESET]
button
↓
↓
Normal state
STEP4: Check that the SV8300 has restarted.
Check that the RUN lump on the CPU blade indicates a normal operating state.
STEP5: Reconnect the communication link with the SV8300
Clear the communication link: click [System] > [Disconnect] (
lish the link: click [System] > [Connect] (
RUN
Off
Blinking blue fast
Blinking blue fast
Blinking blue
slowly
4-7
Chapter 4 Standard Mode
Lamp states
SYSD
Off
Off
Blinking red fast
Off
Page 2-15
Page 2-12 ).
[Implement] Category
SI
Off
Blinking green fast
Off
Off
), then estab-
NWA-033628-001 Rev.1.0